Behringer Music Pedal AB200 User Manual

DUAL A/B SWITCH AB200  
+
The AB200 has no on/off switch. As soon as you  
Thank you for showing your confidence in us by purchasing  
the BEHRINGER AB200. This high-quality 2-channel A/B switch  
is designed for musicians who use several amps and/or  
instruments. The AB200 allows you to switch between gear  
noiselessly and instantaneously without coloring the sound of  
your instrument. The LED always displays which element of  
your system is currently being used.  
insert a jack into the A1 or B1 connector, the AB200  
begins running. When not using the AB200, remove  
the jacks from the connectors. This extends the  
life of the battery.  
The SERIAL NUMBER is located at the bottom of the unit.  
2. APPLICATIONS  
1. CONTROLS AND CONNECTIONS  
Fig. 1.1: Rear view  
Since the controls and connections of the two channels are  
identical, this chapter only describes channel 1.  
IN/OUT 1: this 1/4" TS jack serves as channel 1 input when  
a source is plugged in (guitar, bass etc.) and as channel 1  
output when an amp or an effect is plugged in.  
A1 & B1: these 1/4" TS jacks serve as channel 1 outputs  
when amps or effects are plugged in; they serve as channel  
1 inputs when instruments are plugged in. Only one of  
these connectors can be active at any one time.  
LATCH/NON LATCH: this selector determines the channel  
switch function: when set to LATCH, the switch is latching.  
When set to NON LATCH, the signal will only be routed to or  
from B1 as long as you hold the pedal depressed.  
Fig. 2.1: One instrument / two amps  
Plug your instrument into IN/OUT 1 and the input of each amp  
into one of the A1 and B1 connectors. Pressing the switch 1 will  
toggle between the two amps.  
4
Fig. 1.2: Top view  
SWITCH 1: this switch allows you to assign the IN/OUT 1  
signal to A1 or B1 when IN/OUT 1 is used as an input.  
Otherwise, the switch assigns the A1 or B1 signal to  
IN/OUT 1 when A1 and B1 are used as inputs. The A1 and  
B1 LEDs display which connector is currently active.  
Depending on the selector  
position, shortly press the  
switch (LATCH) or hold it down during the whole commutation  
time (NON LATCH) to toggle between A1 and B1.  
Fig. 2.2: Two instruments / one amp  
Plug each of your instruments into one of the A1 and B1  
connectors and the amp input into IN/OUT 1. Pressing the switch  
1 will toggle between the two instruments.  
To install or replace the 9 V battery, please carefully unscrew the  
bottom plate and open the enclosure of the AB200. After installing  
close the unit again by using all screws you removed before.  
 

4XEM Gas Grill C86 User Manual
AEG Switch MBS 2000 User Manual
Aigo MP3 Player F820 PLUS User Manual
Aiwa Car Stereo System XP Z3C User Manual
Allied Telesis Switch AT GS900 16 V2 User Manual
Amana Clothes Dryer NGD4500V User Manual
Americana Appliances Dishwasher ADW1000K User Manual
Atlona Car Amplifier AT AV14 User Manual
Audiovox Speaker CE208BT User Manual
BB Electronics Network Card 232HSPCC User Manual