Behringer Music Pedal DR400 User Manual

DIGITAL REVERB/DELAY DR400  
Digital Stereo Reverb/Delay Effects Pedal  
Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL REVERB/  
DELAY DR400. This Reverb/Delay effects pedal delivers 24-bit high-resolution stereo reverb and  
delay effects. Experience state-of-the-art sounds comparable to studio processors in one compact pedal.  
1. Controls  
(1) Select the effect mode via the MODE  
(5)  
(4)  
(2)  
(1)  
switch (see table below).  
(2) Depending on the selected mode,  
this knob adjusts the reverb time or  
the delay time.  
(7)  
(6)  
(3) Use the ¼" TS IN connector to plug in  
the instrument cable.  
(3)  
(4) The BALANCE control determines  
the balance between the direct  
(dry instrument) signal and the  
effect sound.  
(5) In REVERB mode, this knob adjusts  
the reverbs’ tonal character. In delay  
and DLY+rev mode, this knob  
adjusts the amount of feedback  
(number of repetitions).  
(8)  
1
1
Effect description  
2
3
8
Short delay (32 - 128 ms)  
Delay time  
Delay time  
Delay time  
Delay time  
Delay time  
Delay time  
Delay time  
Reverb time  
Reverb time  
Reverb time  
Reverb time  
Feedback  
Feedback  
Feedback  
Feedback  
Feedback  
Feedback  
Feedback  
Tone  
2
Medium delay (128 - 500 ms)  
Long delay (500 - 2000 ms)  
3
4
Delay+small room (32 - 2000 ms)  
Delay+big room (32 - 2000 ms)  
Delay+concert hall (32 - 2000 ms)  
Delay+reverb plate (32 - 2000 ms)  
5
6
7
8
Simulates the reverb of a small room  
Simulates the reverb of a big room  
Simulates the reverb of a concert hall  
Simulates the sound of a reverb plate  
9
Tone  
10  
11  
Tone  
Tone  
(6) The two ¼" TS connectors OUT A and OUT B send the signal to your amp or other effects devices.  
Use both connectors if you want to achieve a full stereo effect. For mono use, just plug in OUT A.  
(7) The ON/BATT LED illuminates when the effect is activated. It also serves as a  
battery level indicator.  
(8) Use the foot switch to activate/deactivate the effect. When pressing the foot switch  
2 seconds or longer, you can tap in the delay time (ON/BATT LED flashes).  
(9) Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).  
 

Acnodes Waffle Iron AP4510 User Manual
ADC Satellite TV System 75 192 User Manual
Agilent Technologies Network Hardware 8510C User Manual
Alienware Laptop D05S User Manual
Alliance Laundry Systems Washer HC100 User Manual
Allied Air Enterprises GPS Receiver KLN 90B User Manual
American Standard Indoor Furnishings 0554700 User Manual
ATMT MP3 Player MP160 User Manual
BC Speakers Speaker 15NW100 User Manual
Beckett Water Gardening Fishing Equipment FNB813 User Manual