Behringer Noise Reduction Machine NR300 User Manual

NOISE REDUCER NR300  
Thank you for showing your confidence in us by purchasing the BEHRINGER NOISE  
REDUCER NR300. This ultimate effects pedal is specifically designed to eliminate unwanted  
noise and hum without altering your tone. Thanks to its high-performance features it  
preserves the original attack and envelope while leaving your playing and dynamics intact.  
1. CONTROLS  
Top view  
This MODE switch allows you to chose between MUTE and REDUCTION mode.  
Pressing the pedal in MUTE mode results in muting the whole input signal, to reduce  
noises in during pauses for example. In REDUCTION mode, quiet passages (when  
noise or hum would get obvious to the listener) are effectively reduced. Adjustments  
to threshold and decay settings are necessary in this case (see below).  
Use the THRESH(old) control to define a level threshold in REDUCTION mode.  
When the input signal falls below this value, the unit starts reducing the signal.  
The DECAY control determines how fast the signal reduction is released when the  
input signal exceeds the threshold value again.  
The MUTE/BATT LED illuminates when the effect is activated. It also serves as a  
battery level indicator.  
The REDUCTION LED illuminates when the input level falls below the threshold  
and starts getting reduced.  
Use the footswitch to activate/deactivate the effect.  
Use this 1/4" TS IN connector to plug in the instrument cable.  
The 1/4" TS OUT connector sends the signal to your amp.  
Use this 1/4" TS SEND connector to connect it to the input of an external effect unit. This  
way you can feed in an effect signal while simultaneously eliminating noises from the unit.  
The 1/4" TS RETURN connector is used to feed in the external effect signal.  
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).  
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or  
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be  
careful not to scratch the unit.  
+
The NR300 has no on/off switch. As soon as you insert the jack into the IN  
connector, the NR300 begins running. When not using the NR300, remove  
the jack from the IN connector. This extends the life of the battery.  
The SERIAL NUMBER is located at the bottom.  
 

Accton Technology Mobility Aid WA 5001 User Manual
ADI Systems Marine Radio AT 201 User Manual
Airlink Switch UG AGIGA5SW 1105 User Manual
AOC Flat Panel Television A27W231 User Manual
Apple Network Card PCI E x8 User Manual
Athena Technologies Speaker 3PAB005E User Manual
Atlona TV Cables AT HD610 User Manual
Audiovox Car Stereo System ACD 28 User Manual
Axis Communications Home Theater Server AXIS 82+ User Manual
Bakers Pride Oven Griddle XSG 36 User Manual